RESEARCH 》 Off-Grid Home Lab Research Solar Installation

TrueBench is an unique open-source benchmarking system in which the core system performance and efficiency parameters are measured at extreme high resolution in the order of several million/billion µ-seconds for a given specific task. TrueBench is a part of The TOFFEE Project research. With TrueBench Raspberry Pi 3, Raspberry Pi 2B and Raspberry Pi 2 are benchmarked and you can do a comparative analysis with standard mainstream x86 devices.

Demo TOFFEE_DataCenter WAN Optimization VM (in VirtualBox) Test Setup

Internet optimization through TOFFEE-DataCenter WAN Optimization Demo

Today I have done a test setup so that I can able to connect my Android Samsung Tab via TOFFEE DataCenter. Below is my complete test topology of my setup. For demo (and research/development) context I configured TOFFEE DataCenter in engineering debug mode. So that I do not need two devices for this purpose.

Assume you have two sites (such as Site-A and Site-B) connected via slow/critical WAN link as shown below. You can optimize this link by saving the bandwidth as well possibly improve the speed. However, the WAN speed can be optimized only if the WAN link speeds are below that of the processing latency of your TOFFEE installed hardware. Assume your WAN link is 12Mbps, and assume the maximum WAN optimization speed/capacity of Raspberry Pi is 20Mbps, then your link will get speed optimization too. And in another case, assume your WAN link is 50Mbps, then using the Raspberry Pi as WAN Optimization device will actually increase the latency (i.e slows the WAN link). But in all the cases the bandwidth savings should be the same irrespective of the WAN link speed. In other words, if you want to cut down the WAN link costs via this WAN Optimization set up, you can always get it since it reduces the overall bandwidth in almost all the cases (including encrypted and pre-compressed data).

Internet optimization through TOFFEE-DataCenter WAN Optimization Demo

The TOFFEE Project :: TOFFEE-DataCenter :: Linux Open-Source WAN Optimization

The TOFFEE Project website is hosted on Inmotion Hosting. And so I am looking for alternate hosting provider to build my first CDN node. My plan is to make multiple sub-domains of my website such as cdn1.the-toffee-project.org, cdn2.the-toffee-project.org and point each of this corresponding subdomain(s) to various alternative web hosting servers geographically spread across the world. Sometimes choosing the same vendor for multiple CDN nodes may result multiple servers existing in the data-center. And this becomes an issue if there is some catastrophic network disaster.

Here is my power-consumption measurements of various devices deployed within my home lab. I measured via my kill-a-watt sort of power-meter which is fairly reliable and accurate. I checked its accuracy with various standard load such as Philips LED laps and other constant power-consuming devices to make sure that the power-meter is precise.

When you are dealing Deep Space Networks (DSN) one among the most challenging parts is the Interplanetary distances and communicating data across such vast distances. This is where we are not dealing with common Internet type traffic such as HTTP/FTP/VoIP/etc but it is completely different when it comes to DSN so far. So optimizing data in DSN becomes mandatory. For example if you think one of the Mars Rovers, they have used LZO lossless compression.

I have a huge repository (or collection) of sample Wireshark packet capture files for reference. I use them extensively for research and development of TOFFEE as well to understand various protocol PDUs and protocol standards. I personally collected various test captures via Wireshark during my test and experimental research setup during the course of TOFFEE development. Say if you are a student and learning Networking and or say VoIP data and VoIP packets, you can analyse my VoIP sample Wireshark captures. Or in other case assume you are doing some quick research (or development) and want to refer few handful of VoIP packets then you can download and analyse my sample packet capture files.

Here is my home lab monthly power-consumption readings for research. This will help to measure and monitor the overall power usage and assess the power requirements. This will help me in future purchases such as UPS, battery upgrades and so on. And as well remove replace old obsolete hardware with new less power-consuming devices.