VIDEOS 》 Tracking Live Network Application Data - in a WAN Acceleration (WAN Optimization) Device

Here is a complete chart comprising popular communication data network standards and their respective transfer rates. I hope this reference chart will help network engineers and network software developers while performing networking tests and experiments, building WAN/network products, building WAN simulated networks of a specific standard and so on. This may also helps us to track technological advancements of communication data networks.

Network MTU research and optimization of WAN Links

Assume you have two sites (such as Site-A and Site-B) connected via slow/critical WAN link as shown below. You can optimize this link by saving the bandwidth as well possibly improve the speed. However, the WAN speed can be optimized only if the WAN link speeds are below that of the processing latency of your TOFFEE installed hardware. Assume your WAN link is 12Mbps, and assume the maximum WAN optimization speed/capacity of Raspberry Pi is 20Mbps, then your link will get speed optimization too. And in another case, assume your WAN link is 50Mbps, then using the Raspberry Pi as WAN Optimization device will actually increase the latency (i.e slows the WAN link). But in all the cases the bandwidth savings should be the same irrespective of the WAN link speed. In other words, if you want to cut down the WAN link costs via this WAN Optimization set up, you can always get it since it reduces the overall bandwidth in almost all the cases (including encrypted and pre-compressed data).

Here is my home lab monthly power-consumption readings for research. This will help to measure and monitor the overall power usage and assess the power requirements. This will help me in future purchases such as UPS, battery upgrades and so on. And as well remove replace old obsolete hardware with new less power-consuming devices.

When you build a WAN Optimization device with TOFFEE the entire packet processing (data optimization) takes place in software layer or in other words more precisely Operating System kernel space. However if you have any compression or encryption hardware accelerator hardware card the parts of the TOFFEE packet processing modules can be offloaded to hardware layer and thus improving its efficiency.

The TOFFEE Project :: TOFFEE-DataCenter :: Linux Open-Source WAN Optimization

TOFFEE Fudge is a simple intuitive Network Packet Generator which can be used to create custom test synthetic Network Packets and can be used in various applications such as networking research, network infrastructure troubleshooting, ethical hacking, as a network software development tool and so on.

TOFFEE Optimized Satellite ISP Network: TOFFEE/TOFFEE-DataCenter can be used to optimize Satellite Networks (Satellite based Internet Networks, VoIP, Data, private leased-links) as shown. Ground station transponders can be connected via array of TOFFEE Devices and in the remote CPE can have dedicated or inbuilt TOFFEE with which you can establish a WAN Optimized Satellite Network Tunnel as shown.

My 500GB Seagate Barracuda 7200RPM hard-drive suddenly started making mild clicking noise. I found this happening since morning. I was suspicious that something wrong in this drive and when I opened the Linux Disks app, I can find the cause of this issue. The disk is increasingly getting read errors. Besides I can see various other parameters such as Power-On Hours, Temperature, Head flying hours, etc.